“
“The purpose of the study was to evaluate the effect of the number of supporting implants and different retentive mechanisms on load transfer characteristics of mandibular overdentures. Two photoelastic models of edentulous mandibles were fabricated having two

and four cylindrical implants (Calcitek, 4 × 13 mm) embedded in the parasymphyseal area. Four attachment systems were evaluated: single anchor attachment (ERA), bar-clip, bar with distally placed ball attachments, and bar with distally placed extracoronal rigid attachments (Easy Slot). A 133 N vertical force was applied unilaterally to the Panobinostat purchase central fossa of the right first molar. The resulting stresses of the models were observed and recorded photographically in the field of a circular polariscope. The highest stresses were observed with the bar with distally placed extracoronal rigid attachment (Easy Slot) design, followed by bar-ball, bar, and the single anchor attachment (ERA) for both models. The lowest stress was observed with the single anchor attachment (ERA) design for both models. There were slight differences in stress values around implants in both models. For all tested

attachments on both models, the stress was concentrated on the ipsilateral implant. The bar-clip system allowed the distribution of load to all supporting implants in both models. Although the highest stress level observed with all attachment Alisertib in vivo systems was moderate, the bar-Easy Slot attachment showed the highest stresses. The lowest stress was observed with the single anchor attachment (ERA) design for both models. Varying the

number of implants had no significant effect on stress values around supporting implants. “
“This in vitro study was undertaken to evaluate the effects of different demineralization-inhibiting methods on the shear bond strength (SBS) of glass-ceramics. Ninety extracted intact human mandibular lateral insicors were randomly divided into six equal groups. Group C was left untreated, while enamel subsurface demineralization was induced in the other groups. In group D, porcelain discs (3 mm in diameter) were cemented to demineralized enamel by using total-etch photopolymerizing luting composite resin without pretreatment. Demineralized specimens in groups F, CA, M, and I were pretreated selleck with fluoride gel, CPP-ACP paste, microabrasion, and resin infiltration, respectively, and then porcelain discs were cemented. SBS (MPa) was calculated from the failure load (N) per bonded area (mm2). Fracture types were examined by optical microscopy (40× magnification). Data were analyzed with ANOVA, Tukey’s test, and G-test. ANOVA revealed significant intergroup differences (p < 0.01). No significant differences in SBS (MPa) were found between groups C (19.48 ± 2.0) and I (20.02 ± 1.6). Lower SBS values were recorded in groups D (7.93 ± 0.8), F (12.51 ± 1.5), CA (17.08 ± 1.3), and M (14.84 ± 1.4).