Due to its much lower cost, most EBL systems for academic research are based on scanning electron microscope (SEM) without dynamic compensation. selleck chemicals llc For such systems, the beam is typically optimized (stigmation compensated and well focused) at high magnification (e.g. ×100,000), so only the central spot of the writing field is optimized to attain a beam spot size of a few nanometers. At a distance farther away from the center, the beam spot is larger due to beam distortion and deterioration of focus. Due to the lack of in situ feedback, conventional EBL is a ‘blind’ open-loop process where the

exposed pattern is examined only after ex situ resist development, which is too late for any improvement. Therefore, it is highly desirable to examine in situ the electron beam and optimize it before the time-consuming exposure of large-area pattern. This is buy CA4P particularly important for exposing large-area patterns that, in order to keep a reasonable exposure time, necessitates a large writing field and high beam current, which both magnify the issue of beam enlargement and distortion near the writing field

corners. For instance, to expose a (1 cm)2 area with a writing field of (100 μm)2 using the Raith 150TWO system (Dortmund, Germany), the total time for stage Decitabine concentration movement (104 movements to expose the 104 writing fields) would be 40,000 s (11 h) for a stage movement Geneticin supplier time between adjacent writing fields of 4 s. Obviously, the larger the pattern area is, the more

significant the use of a large writing field is, though at the cost of reduced resolution. Furthermore, if all the structures for a device can be put inside one large writing field, the stitching error between the structures would be eliminated. Previously in situ feedback on electron beam drift based on imaging a mark or a grid pre-patterned on the substrate was reported [1–3], but no in situ feedback on electron beam spot size has been demonstrated. Here, we propose to use self-developing resist, for which the exposed pattern shows up right upon exposure without an extra development step, as in situ feedback for the first time. With this closed-loop process, the beam spot can be optimized globally across an entire writing field, such that the beam spot size is evenly distributed. That is, the optimized beam spot size will be larger at the writing field center than obtained using conventional beam adjustment procedure, but much smaller near the writing field corners, thus allowing reasonably high-resolution patterning across the entire large writing field.